烤漆房废气处理设备,喷漆房废气处理设备,喷漆废气处理设备,喷漆废气处理

光氧等离子一体机原理及特点

　　原理介绍

　　1、 本产品利用特制的高能光束照射恶臭气体，裂解恶臭气体如：氨、三甲胺、硫化氢、甲硫氢、甲硫醇、甲硫醚、二甲二硫、二硫化碳和苯乙烯，硫化物H2S、VOC类，苯、甲苯、二甲苯的分子链结构，使有机或无机高分子恶臭化合物分子链，在高能紫外线光束照射下，降解转变成低分子化合物，如CO2、H2O等。

　　2 、利用高能高臭氧UV紫外线光束分解空气中的氧分子产生游离氧，即活性氧，因游离氧所携正负电子不平衡所以需与氧分子结合，进而产生臭氧。

　　UV＋O2→O-+O＊（活性氧）O+O2→O3（臭氧），众所周知臭氧对有机物具有极强的氧化作用，对恶臭气体及其它刺激性异味有立竿见影的清除效果。

　　3 、恶臭气体利用排风设备输入到本净化设备后，净化设备运用高能C波光束及臭氧对恶臭气体进行协同分解氧化反应，使恶臭气体物质其降解转化成低分子化合物、水和二氧化碳，再通过排风管道排出室外。

　　4 、利用高能UV光束裂解恶臭气体中细菌的分子键，破坏细菌的核酸（DNA），再通过臭氧进行氧化反应，彻底达到脱臭及杀灭细菌的目的。

　　二、性能参数

　　1、处理风量：2000m3/h---100000 m3/h；

　　2、有机废气净化效率：≥95%；

　　3、设备阻力：≤300Pa；

　　4、电源电压：220V　 50HZ

　　5、电功率：500W-6000W

　　6、备噪声：≤45Db

　　三、技术特点

　　1 、高效除恶臭：能高效去除挥发性有机物（VOC）、无机物、硫化氢、氨气、硫醇类等主要污染物，以及各种恶臭味，脱臭效率最高可达99%以上，脱臭效果大大超过国家1993年颁布的恶臭污染物排放标准（GB14554-93）。

　　2 、无需添加任何物质：只需要设置相应的排风管道和排风动力，使恶臭气体通过本设备进行脱臭分解净化，无需添加任何物质参与化学反应。，

　　3 、适应性强：可适应高浓度，大气量，不同恶臭气体物质的脱臭净化处理，可每天24小时连续工作，运行稳定可靠。

　　4 、运行成本低：本设备无任何机械动作，无噪音，无需专人管理和日常维护，只需作定期检查，本设备能耗低，（每处理1000立方米/小时，仅耗电约0.2度电能），设备风阻极低＜50pa，可节约大量排风动力能耗。

　　5 、无需预处理：恶臭气体无需进行特殊的预处理，如加温、加湿等，设备工作环境温度在摄氏-30℃－95℃之间，湿度在30%－98%、PH值在2-13之间均可正常工作。

　　6 、设备占地面积小，自重轻：适合于布置紧凑、场地狭小等特殊条件，设备占地面积＜1平方米/处理10000m3/h风量。

　　7 、优质进口材料制造：防火、防腐蚀性能高，性能稳定，使用寿命长。

　　8 、环保高科技专利产品：采用国际上最先进技术理念，通过专家及我公司工程技术人员长期反复的试验，开发研制出的，具有完全自主研发的高科技环保净化产品，可彻底分解恶臭气体中有毒有害物质，并能达到完美的脱臭效果，经分解后的恶臭气体，可完全达到无害化排放，绝不产生二次污染，同时达到高效消毒杀菌的作用。

　　四、 适用范围：

　　炼油厂、橡胶厂、化工厂、制药厂、污水处理厂、垃圾转运站等恶臭气体的脱臭净化处理。

　　五 、产品优势

　　1、净化效率高、运行稳定；

　　2、结构紧凑、新颖、体积小、重量轻、模块化结构设计；

　　3、噪声小于45db（A）、风阻小于300 Pa；

　　4、运行成本低、耗电功率小；

　　5、维护方便、使用寿命长；

　　6、安全可靠，价格合理。

　　六 、安装及说明

　　净化器可安装在风机之前，也可安装在风机之后，建议安装在风机之前；

　　净化器如安装在支架之上时，应与支架紧固连接；

　　净化器与排风管道之间的连接必须密封；

　　净化器可以安装在室内，也可安装在室外，但应有足够的空间用来维护与维修；

　　净化器箱体应可靠接地；

　　净化器本体及电控箱中各电器连接应可靠无误。

Principle introduction
1. this product uses special high energy beam to irradiate the odor gas, such as ammonia, trimethylamine, hydrogen sulfide, 甲, methyl mercaptan, dimethyl sulfide, dimethyl disulfide, carbon disulfide and styrene, sulfur sulfide, VOC, benzene, toluene and xylene molecular chain structure, make the molecular chain of organic or inorganic macromolecule stench, and transform to low molecular compound such as CO2, H2O under high energy ultraviolet light irradiation. 
2. the oxygen molecules in the air are decomposed by high energy high ozone ultraviolet ray beam to produce free oxygen, that is reactive oxygen, because the electron imbalance with the positive and negative electron transport of free oxygen needs to be combined with oxygen molecules to produce ozone. 
U v + O2 → o - + o * ( reactive oxygen ) o + O2 → O3 ( ozone ), it is well known that ozone has strong oxidation effect on organic matter, and has immediate effect on the removal of odor gas and other irritative odors. 
3. after the exhaust equipment of odor gas is used for input to this purification equipment, the purification equipment uses high-energy c wave beam and ozone to cooperate with decomposition oxidation reaction to make the odor gas degradation into low molecular compound, water and carbon dioxide, and then exhaust the outdoor air through the exhaust pipe. 
4. use the molecular key of bacteria in the stench gas to destroy the nucleic acid ( DNA ) of the bacteria, and then oxidize the reaction by ozone, completely achieve the purpose of deodorization and killing bacteria. 
Ii. performance parameters
1. handling air volume: 2000 m3 / h - 100000 m3 / h; 
2. the purification efficiency of organic waste gas: ≥ 95 %; 
3. equipment resistance: ≤ 300 pa; 
4. power supply voltage: 220v 50hz
5. electric power: 500 w - 6000 w
6. noise: ≤ 45 db
Iii. technical characteristics
1. efficient removal of volatile organic compounds ( VOC ), inorganic matter, hydrogen sulfide, ammonia and mercaptan, and all kinds of bad odor, deodorization efficiency up to 99 %, deodorization effect greatly exceed the national emission standard of odor pollutants emitted in 1993 ( GB 14554 - 93 ). 
2. no matter need to be added: only the corresponding exhaust pipe and exhaust power shall be provided so that the odor gas can be deodorization and purified through this equipment without any material involved in chemical reaction. ，
3. strong adaptability: it can adapt to high concentration, atmospheric volume, deodorization and purification of different odor gas substances, can work 24 hours a day continuously, and the operation is stable and reliable. 
4. low operating cost: this equipment does not have any mechanical action, no noise, no special personnel management and daily maintenance, only regular inspection, low energy consumption of this equipment, ( per processing of 1000 cubic meters / hour, only about 0.2 degrees of electricity consumption ), the wind resistance of the equipment is very low < pa, saving a large amount of exhaust power energy. 
5. no pretreatment: the odor gas does not need special pretreatment, such as heating and humidification, the equipment working environment temperature is between - 30 ℃ - 95 ℃, humidity in 30 % - 98 %, ph value between 2 - 13 can work normally. 
6. the equipment occupies small area and light weight: it is suitable for special conditions such as compact layout and small space, and the equipment covers an area < 1 square meter / handling capacity of 10000 m3 / h. 
7. high quality imported materials: fire protection, high corrosion resistance, stable performance and long service life.
Environmental protection and high - tech patent products: using the most advanced technology ideas in the world, through long-term repeated experiments by experts and engineering technicians of our company, the high - tech environmental purification products with complete independent research and development can completely decompose poisonous and harmful substances in the malodorous gases, and achieve the perfect deodorizing effect. the decomposed stench gas can completely achieve harmless emissions without secondary pollution, and at the same time, the effect of high efficiency disinfection and sterilization is achieved. 
Iv. scope of application:
Deodorization treatment of odor gas such as refinery, rubber factory, chemical plant, pharmaceutical factory, sewage treatment plant and refuse transfer station. 
V product advantages
1. high purification efficiency and stable operation; 
2. compact, novel, small size, light weight, modular structure design; 
3. noise is less than 45 db ( a ) and wind resistance is less than 300 pa; 
4. low running cost and low power consumption; 
5. easy maintenance and long service life; 
6. safe and reliable, reasonable price. 
Vi. installation and description
The purifier may be installed before the fan or after the fan, and it is recommended to be installed before the fan; 
If the purifier is installed on the support, it shall be connected with the support. 
The connection between the purifier and the exhaust pipe must be sealed; 
The purifier can be installed in the room or outdoors, but there should be enough space for maintenance and repair. 
The purifier box shall be grounded reliably; 
The main body of the purifier and the electrical connection of the electric control box shall be reliable.